Home 3 Series 2012-2019 (F3x) Bumper Cover Removal Front – 2012-2019 BMW 3 Series (F30)

Bumper Cover Removal Front – 2012-2019 BMW 3 Series (F30)

0
This article is AI free. It contains original content, and was researched and written by our own staff at the BMW Repair Guide. For more information on our AI Free Zone, please click here.
Affiliate link disclosure – The BMW Repair Guide uses affiliate links in their site. For more information on affiliate links, please click here.

Bumper Cover Removal Front – 2012-2019 BMW 3 Series (F30)

This repair procedure gives step by step instructions on removing the front bumper cover on 2012-2019 3 series (F30) vehicles. Removing the front bumper cover is necessary for many repairs, most notably headlight replacement.
Not sure which engine you have in your BMW? Use our engine finder tool to easily identify it!
Possible Symptoms: Not applicable for this repair.
This repair can be used on the following BMW models:
Intermediate level repair.

Step 1 - Purchase Parts

You will need the following parts and supplies to perform this repair.

Step 2 - Repair Procedure

Unless otherwise noted, all vehicle repair step images in this article are copyrighted, and used courtesy of BMW of North America, Inc. .
1. Removing the front bumper cover.
remove the torx screws from top of front bumper cover
Click to enlarge image

- Remove the front rubber gasket (1).

- Remove the 8 torx screws (2).

View part diagram for this step
remove scews and plastic rivets from front underbody protection
Click to enlarge image

- Remove the screws and plastic rivets (1) from underneath the front of the vehicle.

View part diagram for this step
remove the three hex screws securing the wheel housing trim
Click to enlarge image

- Remove the three hex screws (1) securing the left and right wheel housing trim (2) to the bumper cover.

View part diagram for this step
Pro Tip

When disconnecting electrical connections during a repair, wrap them with high visibility blue or green tape so you don't miss any during reassembly.

remove the screws in top of wheel housing
Click to enlarge image

- Carefully pull back the plastic wheel housing trim.

- Remove the screws (1) on top of both right and left wheel housings.

- Pull bumper cover forward slightly and disconnect all electrical connections.

- Remove the bumper cover from the vehicle.

View part diagram for this step
M aerodynamics package - release plastic connectors behind lower portion of bumper
Click to enlarge image

Vehicles with M Aerodynamics Trim Package

- Unfasten plastic connectors (1)(2) behind lower portion of bumper cover on both the right and left side of vehicle.

- Remove the bumper cover from the vehicle.

View part diagram for this step
r-51-11
Copyright BMW Repair Guide 2024 - All Rights Reserved